(!)Due to Microsoft's end of support for Internet Explorer 11 on 15/06/2022, this site does not support the recommended environment.

HR10 Dust-proof Cap

HR10 Dust-proof Cap

Click this image to zoom it.

Move the mouse over the image to zoom

  • Volume Discount

A dust-proof cap to prevent contamination from foreign bodies and protect the connected portion


● Prevents intrusion of dust and foreign matter to the fitting surface when mounted on unused panel mount receptacle.

· Does not have waterproof functionality.

Specifications

HR10 Dust-proof Cap:Related Image

ModelNumber of CoresWeight
g
HR10-7R-C4,60.3
HR10-10R-C10,120.6

More Information

HR10 Dust-proof Cap:Related Image
Part Number
HR10-10R-C
Part NumberMinimum order quantityVolume DiscountDays to Ship RoHS
1 Piece(s)Available

8 Days or more

10

Loading...

  1. 1

Characteristics

Item Contents
Rated Current 2 A or lower
Rated Voltage 14-core: 150 VAC / 200 VDC, Other: 100 VAC / 140 VDC
Peak Voltage 300 VAC or less (500 VAC or less for 4-core) / 1 minute
Insulation Resistance 1,000 MΩ or more / 100 VDC
Contact Resistance 10 mΩ or less / 1 ADC
Compatible Wire Size AWG26 or below Loose Wires or 0.15 mm2 or less Loose Wires

* For applicable wire size, cable finished outer diameter should be within cable clamp inner diameter.

Material / Finish

Item Materials Finish
Body Shell Zinc Alloy Satin Nickel Plated
Pin Contact Brass Silver Plating
Socket Contact Phosphor Bronze Silver Plating
Insulator Polyamide Resin Black

Contact Arrangement Diagram


Connection Work Method (Relay type can be done by the same method.)

Number of Cores Wrench Spacing (mm) D Dimension (mm) Wrench Tightening Force
4.6 7.5 10 1.5 N・m (15 kgf・cm)
10.12 9.5 16 1.5 N・m (15 kgf・cm)

Connector assembly is performed in the following order.
(1) Pass the cable through the cord bushing and connector body, and then solder to the insulator unit contact.
(2) After soldering the wire to the connector, crimp the clamp brackets attached to the connector with the crimp tool (HR10A-TC-02) or pliers.
(3) Fit the insulator unit screw part into the connector body. (Use a wrench and tighten to the values shown in the table.) When tightening the connector body, loosen the D part first so that the solder connection part is not placed under stress.
(4) Tighten the fastening screw so that its tip touches one of the two bosses on the clamp bracket. Note that the fastening screw is fixed with tightening torque of 0.3 N⋅m (3 kgf⋅cm).
(5) Finally, cover the the cord bushing with the connector body.

Connector Insertion and Removal Method

Please check the type/dimensions/specifications of the part HR10-10R-C in the HR10 Dust-proof Cap series.

Additional Products in this Category

Complementary Products

Tech Support

Technical Support
Tel:+52-442-672-7661 ext. 2 then wait and dial 4
E-mail: soportetecnico@misumimex.com
Mon. - Fri. 8 a.m. - 6 p.m.